BMS
The Battery Management System (BMS) interfaces one or more ZCell/ZBM2 units to an energy system
- Choosing the SPS pool size based on application requirements
- BMS Initial Configuration Guide
- BMS CANBus cable wiring
- BMS cabling to ZCell/ZBM2 modules
- Powering the Redflow BMS (and other key control electronics)
- BMS initial physical connection guide
- How the Redflow EED works during a maintenance cycle
- Optimising battery charge rate and maintenance time using BMS Version 1.11
- Using the BMS Digital I/O engine to send signals to external systems
- Deploying a Support Power Supply on the DC bus
- Providing dry-contact relay status signals using a MODBUS-TCP relay module
- Interfacing to the Redflow BMS using MODBUS-RTU (RS485)
- Querying the Redflow BMS using MODBUS-TCP or JSON
- Cabling considerations when connecting more than 12 batteries to a single BMS
- Using SPS mode exclusively (no RUN mode batteries on the system)
- Configuration of BMS-controlled Standby Power System (SPS) battery operation
- Obtaining Technical Support From Redflow
- Determining the local IP address of your BMS
- Resetting the BMS settings